Your cart is empty
Continue Shopping

This is a new aftermarket front lower cab glass that replaces Caterpillar OEM #156-6473. It fits Caterpillar excavators & mini excavators including the 311C and the other models listed below, and is mounted in the front lower cab window position.
This tempered glass pane measures about 831 mm wide × 401 mm high (32.7" × 15.8"), is 5 mm thick, and has a green tint with DOT certification.
Fits the following Caterpillar models:
This is real tempered glass, the same material type Caterpillar used in this position from the factory. Glass resists scratches from wipers, dust and cleaning far better than polycarbonate and stays clear over time. Tempered glass is heat-treated so that, if it does break, it crumbles into small, blunt pieces instead of long sharp shards. If your machine works in forestry, mulching or demolition where flying debris is a risk, see our Caterpillar excavator polycarbonate doors and windshields.
This listing is for the glass pane only. The frame, seals, gaskets and mounting hardware are not included — reuse your existing parts or source them separately. On the 320D, Caterpillar's operator's manual describes the lower front window as a removable pane that lifts out of the window frame.
Not Included: frame, seals, gaskets, mounting hardware.
Yes. Caterpillar's 320D Operation and Maintenance Manual says to raise the lower window out of the window frame and store it in the holder at the rear of the left side cab frame.
It is curved. The 320D operator's manual notes that the lower window is curved and can only be positioned one way in its storage holders, so check the curve direction before you set it in the frame.
Both are green-tint front lower panes of roughly 401 × 831 mm for C and D series cabs. Caterpillar's parts store lists 156-6647 with screws and stoppers included, while 156-6473 is the glass pane on its own.
FridayParts lists 383-6930 together with 156-6473, but Broken Tractor lists its 383-6930 pane at 831 × 412 mm for D and D2 machines, about 11 mm taller than Caterpillar's 401 mm height for 156-6473. Measure your old glass if your machine shows 383-6930.
Yes. The 320D operator's manual describes separate lower window wiper and washer switches, and Cat's 320D L spec sheet lists upper and lower windshield wipers and washers.
Caterpillar®, CAT® are registered trademarks of Caterpillar Inc. Forestry Doors is not affiliated with Caterpillar; OEM numbers are listed for cross-reference only.